CARBATEC 630mm Sander Wide Drum WDS-630C

SKU
..121077
MPN WDS-630C
In Stock
$4300
 

GET TO WORK NOW, PAY LATER Click to see your options

Paypal
Available for orders between $30 - $2,000
Zip
Available for orders up to $5,000
Afterpay
Love tools? Start earning points to redeem rewards on your next purchase Log in or Sign Up to redeem today!
Product Review Winner
Top 100 Relailer
30 Day Online Returns' with 'Australia's largest professional tool retailer

Features powerful 3hp / 230v single phase motor. The variable speed rubberised feed belt protects the underside of panels during infeed while holding them in place to pass under the sanding heads. Abrasives are spirally wound onto the both drums and are tensioned at both ends with spring clips - setup takes only a few minutes, even less with some practice. 

The optimal way for the drums to be configured is with coarse paper on the front drum and fine paper on the rear to allow you to produce a finished board in one pass. This dramatically reduces your hand sanding time and is a wonderful common sense. A drum setting gauge is factory fitted and helps make this process simple and easy. 

Adequate dust extraction – 2HP (at least 1200CFM) is a prerequisite for using this machine. Without adequate dust extraction papers become clogged and will not perform optimally. 

Requires 15Amp power point and circuit which must be installed by a licensed electrician.

  • 3HP, 240v induction motor
  • 620mm sanding width
  • Dual drum capacity
  • Rubberised feed platen
  • Feed speeds range from 1 to 6 metres per minute
  • Two 4" (100mm) dust ports
  • Dust extraction required for optimal performance
Specification
Part No WDS-630C
Barcode 9333827016567
Brand Carbatec

Reviews

Write Your Own Review